In this project we will explore the use of a novel prosthesis controller based on the principle of Principal Component Analysis to enable seamless posture selection in high degree-of-freedom (DOF) prosthetic hands. The goal of this project is to develop a multi-degree of freedom (DOF) hand prosthesis posture controller that uses myoelectric signals (EMG) as control inputs and which has been dimensionally optimized using principal component analysis (PCA). Currently available multi-DOF hand prostheses cannot be fully utilized because there are fewer control inputs than the number of DOFs to be controlled (i.e. an underactuated system). Based on work from the neuroscience literature1 it has been shown that grasping is a 'low dimensional'task. This work used PCA to quantify the principal components (number of dimensions) involved in grasping. It was found that grasping tasks could be well described by the first two principal components. Two principal components implies that the posture of a multi-DOF hand, while grasping, can be controlled using only 2 degrees-of-control. This is an encouraging finding since current clinical upper limb prosthetic practice indicates only 3 or 4 independent myoelectric sites can be located on the residual limb of a typical person with a transradial amputation. We propose to explore the merits of a hand posture controller based on the first two principal components described by Santello et al.1 and driven using 2, 3 or 4 myoelectric sites. Santello et al. measured 15 joint angles in the hand of the subjects while 'grasping'57 household objects. The resulting analysis showed a high amount of covariance between the joints while grasping different objects. A principal component analysis showed that the first two principal components accounted for 84% of the variance. This result suggests that, for grasping tasks, control of our 22 DOF natural hand reduces to a largely 2 dimensional control problem. Applying this finding to the control of multi-articulated prosthetic hands means we can use 2-4 myoelectrodes yet still be able to seamlessly move between postures in a multi-DOF hand. We will develop a control algorithm that will map the myoelectric signals to weighted combinations of Santello et al.s first two principal components to yield a desired posture. All functional grasp as defined by Keller et al., (1947) are achievable by varying the degree to which either principal component is weighted. This controller will direct high-dimension grasps with only 3 or 4 myoelectric sites and therefore control a multi-degree of freedom prosthetic hand using currently available clinical practices. This is of relevance because there are a number of new commercially available hands coming onto the market with articulated fingers and multi- positional thumbs - but with no way to select between grasps in a easy manner. We will demonstrate an EMG- driven PCA-based controller by having it drive a Bebionic Hand2 which has been modified to have a two degree-of-freedom thumb - converting it into a 6 DOF hand. 1 Santello, M., Flanders, M., and Soechting J.F., (1998): Postural hand synergies for tool use. J. Neuroscience, 18(23)10105-10115. 2 RSLSteeper, Rochester, United Kingdom.
We seek to develop a novel prosthesis controller based on the principle of Principal Component Analysis to enable seamless posture selection with the new generation of multi-articulating hands. Veterans with upper- limb amputations want prosthetic hands with individually articulating fingers but posture selection in these hands is currently performed through sequences of pulses which imposes state based sequential control. Sequential control tends to be slow and cumbersome and places excessive mental loading on the user. We are proposing to develop a hand posture controller based on a finding by Santello et al. (1998) who found that while grasping a number of objects the first two principal components of the hand's joint angles accounted for ~80% of the variance in the resultant hand postures. This result suggests that, for grasping tasks, the control of a high degree-of-freedom hand can be reduced to 2 dimensional control problems. We propose to develop a controller based on this result and to evaluate it with veterans with upper-limb amputation.
| Segil, Jacob L; Weir, Richard F (2015) Novel postural control algorithm for control of multifunctional myoelectric prosthetic hands. J Rehabil Res Dev 52:449-66 |
| Cipriani, Christian; Segil, Jacob L; Clemente, Francesco et al. (2014) Humans can integrate feedback of discrete events in their sensorimotor control of a robotic hand. Exp Brain Res 232:3421-9 |
| Segil, Jacob L; Controzzi, Marco; Weir, Richard F ff et al. (2014) Comparative study of state-of-the-art myoelectric controllers for multigrasp prosthetic hands. J Rehabil Res Dev 51:1439-54 |
| Segil, Jacob L; Weir, Richard F ff (2014) Design and validation of a morphing myoelectric hand posture controller based on principal component analysis of human grasping. IEEE Trans Neural Syst Rehabil Eng 22:249-57 |
