This subproject is one of many research subprojects utilizing theresources provided by a Center grant funded by NIH/NCRR. The subproject andinvestigator (PI) may have received primary funding from another NIH source,and thus could be represented in other CRISP entries. The institution listed isfor the Center, which is not necessarily the institution for the investigator.In this study, CAD, hot ECD and EDD were utilized to study the fragmentation patterns of linear and branched glycans. Sodiated and permethylated glycans were analyzed by both CAD and hot ECD experiments available in a custom-built ESI-FTICR MS, and the resulting spectra provided complementary structural information. CAD generated major B and Y fragment ions whereas while C and Z products dominated the hot ECD produced major C and Z ions. A-type cross-ring cleavages were present in spectra generated by CAD while complementary A- and X-type pairs happened resulted from hot ECD. Especially 0,4An and 3,5An ions determined defined the linkage position of the upper branch. More abundant internal fragments were observed in CAD than in hot ECD spectra. Since acidic glycans form more stable spray in the negative mode than in the positive mode, the EDD experiment on the native glycans was performed in the negative mode and it generated more cross-ring cleavages than CAD. The native glycans, including those released from glycoproteins, were permethylated by dissolving them in Me2SO, followed by treatment with powdered sodium hydroxide and methyl iodide. The purified and dried permethylated glycans were dissolved in 60/40 25 mM NaOH/50% methanol to a concentration of ~5-10 pmol/ l solution. For the native glycans, the samples were dissolved in 50/50 MeOH/H2O with 0.2% ammonium hydroxide. The results are summarized briefly here. Sodiated and permethylated linear malto-oligosaccharides: The fragmentation patterns of sodiated and permethylated linear (Glc)6-(Glc)9 are very similar. The glycosidic cleavages (B, Y, C, and Z ions), cross-ring cleavages (A and X ions), and internal cleavages (B/Y and C/Y ions) were all observed. Due to their highly symmetric structures, Bn and Zn, Cn and Yn, 0,2Xn and 2,4An+1 ions are isobaric. In order to differentiate the pairs, the maltoheptaose was reduced by sodium cyanoborohydride. Extensive fragment ions were detected in CAD and the Y ions had the highest abundance. Hot ECD provided cleavages similar to CAD, though with fewer cross-ring cleavages. Sodiated and permethylated N-linked branched glycans: CAD and hot ECD on sodiated and permethylated high-mannose and complex type (asialo-, disialyated biantennary) N-linked glycans provided complementary structural information. The sequences of these glycans were confirmed by B, Y ions in CAD and C, Z ions in hot ECD. The branching, composition and linkage information was determined by cross-ring cleavages (A-type in CAD and complementary A and X pairs in hot ECD). Internal fragments are particularly frequent in CAD but also occur in ECD. In agreement with the literature, higher collision energy was required to fragment the backbone of sialylated glycans to the same extent as their asialo counterparts. The triply charged molecular ion of a sodiated and permethylated disialylated-biantennary N-linked glycan was abundant and was fragmented by the hot ECD generating extensive fragment ions (glycosidic and complementary pairs of cross-ring cleavages) to fully confirm its sequence, branching, and linkage assignments. Fragmentation of the larger high-mannose type glycans such as GlcNAc2Man7-9 by ECD is still difficult but may be improved by activated ion ECD. EDD of native linear and branched glycans: EDD experiments on the native linear and branched N-linked glycans generated more cross-ring cleavages than CAD and those cross-ring cleavages could be used to differentiate isomers.
Showing the most recent 10 out of 253 publications
