Minimally invasive cardiac procedures using endovascular access under x-ray fluoroscopic guidance have enabled treatment of patients that previously would have required open-heart surgery. Such minimally invasive procedures are preferred because of their lower risk, faster recovery and lower cost. One of the fastest growing procedures is ablation for treatment of atrial fibrillation - a problem eventually suffered by 20% of the population and a significant contributor to stroke, patient morbidity and mortality. While promising, procedure success rates are still only ~50% for the first intervention, and even with subsequent interventions, final outcome success hovers at ~70%. It is hypothesized that a major factor contributing to the limited success rate is the lack of precise knowledge about the exact number and location of the created lesions. We propose to leverage and expand upon our recent development of ECG gated cardiac C-arm CT to provide three-dimensional imaging during the interventional procedure. By generating 3D images utilizing the x-ray system in the interventional suite, the error prone and time-consuming spatio-temporal registration with prior CT or MRI exams will be avoided. Detailed three- dimensional images reflecting the current state of the patient will be combined with electroanatomical maps to optimally assist the interventionalist.
We aim to also reduce the radiation dose to both patients and staff by shortening the time needed for fluoroscopic guidance and by incorporating multi-dimensional noise reduction algorithms. We will develop image quality improvements by addressing under-sampling, acquisition timing and temporal definition, and by developing hardware and software to improve low-contrast performance, registration accuracy and visualization. One of our goals is to demonstrate the ability to depict the left atrium and pulmonary veins to provide guidance accuracy of better then 2 mm, and to reduce the time required for registration by 50% (~20 minutes). With these developments our ultimate goal is to accomplish faster and more accurate catheter based interventions with an equivalent success rate as surgical procedures (80-90%). The significance of this project is further amplified by the fact that the technology developed could eventually impact many other current minimally invasive procedures, and also future procedures as they become available, such as endocardial injection of stem cells for treatment of myocardial infarction. Project Narrative The project aims to provide high-quality 3D CT images of the beating heart in the interventional suite during an interventional procedure. We believe that providing images that reflect the true status of the patient at the time of intervention, when combined with device-tracking hardware, will provide significant improvements in accuracy and reduction in procedure times for complicated procedures such as radiofrequency ablation of atrial fibrillation. We are also developing new image processing and reconstruction approaches that may permit 3D visualization of radiofrequency lesions in the heart wall that would allow intra-procedural monitoring of lesion placement. Access to such images, during an interventional procedure, could also enable new, directed treatments for myocardial infarction by allowing accurate guidance of therapy (cell, drug etc.) directly to the affected tissue.

Agency
National Institute of Health (NIH)
Institute
National Heart, Lung, and Blood Institute (NHLBI)
Type
Research Project (R01)
Project #
1R01HL087917-01A2
Application #
7554192
Study Section
Biomedical Imaging Technology Study Section (BMIT)
Program Officer
Buxton, Denis B
Project Start
2009-08-15
Project End
2011-07-31
Budget Start
2009-08-15
Budget End
2010-07-31
Support Year
1
Fiscal Year
2009
Total Cost
$758,658
Indirect Cost
Name
Stanford University
Department
Radiation-Diagnostic/Oncology
Type
Schools of Medicine
DUNS #
009214214
City
Stanford
State
CA
Country
United States
Zip Code
94305
Choi, Jang-Hwan; Constantin, Dragos; Ganguly, Arundhuti et al. (2015) Practical dose point-based methods to characterize dose distribution in a stationary elliptical body phantom for a cone-beam C-arm CT system. Med Phys 42:4920-32
Ritschl, Ludwig; Fahrig, Rebecca; Knaup, Michael et al. (2015) Robust primary modulation-based scatter estimation for cone-beam CT. Med Phys 42:469-78
Girard, Erin E; Al-Ahmad, Amin; Rosenberg, Jarrett et al. (2015) Contrast-Enhanced C-arm Computed Tomography Imaging of Myocardial Infarction in the Interventional Suite. Invest Radiol 50:384-91
Müller, Kerstin; Maier, Andreas K; Zheng, Yefeng et al. (2014) Interventional heart wall motion analysis with cardiac C-arm CT systems. Phys Med Biol 59:2265-84
Choi, Jang-Hwan; Maier, Andreas; Keil, Andreas et al. (2014) Fiducial marker-based correction for involuntary motion in weight-bearing C-arm CT scanning of knees. II. Experiment. Med Phys 41:061902
Müller, K; Maier, A K; Schwemmer, C et al. (2014) Image artefact propagation in motion estimation and reconstruction in interventional cardiac C-arm CT. Phys Med Biol 59:3121-38
Bourier, Felix; Fahrig, Rebecca; Wang, Paul et al. (2014) Accuracy assessment of catheter guidance technology in electrophysiology procedures: a comparison of a new 3D-based fluoroscopy navigation system to current electroanatomic mapping systems. J Cardiovasc Electrophysiol 25:74-83
Maier, Andreas; Hofmann, Hannes G; Berger, Martin et al. (2013) CONRAD--a software framework for cone-beam imaging in radiology. Med Phys 40:111914
Müller, Kerstin; Schwemmer, Chris; Hornegger, Joachim et al. (2013) Evaluation of interpolation methods for surface-based motion compensated tomographic reconstruction for cardiac angiographic C-arm data. Med Phys 40:031107
Choi, Jang-Hwan; Fahrig, Rebecca; Keil, Andreas et al. (2013) Fiducial marker-based correction for involuntary motion in weight-bearing C-arm CT scanning of knees. Part I. Numerical model-based optimization. Med Phys 40:091905

Showing the most recent 10 out of 19 publications